3EYE Universal Head-Down Holder Mounting Guide

3EYE

2026

Universal Head-Down Holder Mounting Guide

Version: 1.0


Table of Contents


The universal holder can be installed on hard or soft surfaces using six screws. For a permanent installation, also use a transparent shoe adhesive.

Temporary Installation: Screws Only

Figure 1 Temporary Mounting

  1. Place the hole template on the back of the fabric.
  2. Use the template to position and insert the six screws.
  3. Remove the template.
  4. From the front, align the holder’s holes with the screws.
  5. Tighten the screws until their heads are flush with the fabric. If you are installing the holder on elastic fabric, make sure the screws are fully tightened and flush so they cannot scratch your skin.

Permanent Installation: Screws and Adhesive

Figure 2 Permanent Mounting

  1. Place the hole template on the back of the fabric.
  2. Use the template to position and insert the six screws.
  3. Remove the template.
  4. Place the template on the front of the fabric and trace around both its inner and outer edges. These lines mark where to apply the adhesive.
  5. Apply shoe adhesive to both the holder and the fabric, following the adhesive manufacturer’s instructions. Wait as directed.
  6. Tighten the screws until their heads are flush with the fabric. If you are installing the holder on elastic fabric, make sure the screws are fully tightened and flush so they cannot scratch your skin.

Warning: Shoe adhesive can soak into fabric and may be difficult to remove. Removing the holder may not remove all the adhesive.

Shoe adhesive is flexible and water-resistant. You can wash the fabric in warm water below 40°C. Bison Shoe Glue is an inexpensive option; other shoe adhesives may also work.